Create Event Wizard - Page 5
|
<< Click to Display Table of Contents >> Navigation: Dialogs and Views > File configuration dialogs > Create Event Wizard > Create Event Wizard - Page 5 |
The "Create Event Wizard" guides you through the setting up of a new event file. Use the File / New Event File menu to open the wizard.
On this page, the Wizard asks you to configure if this event uses one single map or multiple maps. This configuration is merely setting up the event file initially and can later be changed.
Keep in mind that the selection on this page can later be changed by using these dialogs: Canvas / Map - Setup Map dialog and Canvas / Controls - Setup Controls Dialog
The intended use of the options:
One map file |
- one print scale This is the basic case - use this option if you are unsure. - two print scales Use this option when you have ONE map file, and you plan to print different courses at different scales. You enter two different print scales. Condes places your map on two different canvases and sets the print scale for each canvas according to your input. When you create a control one one canvas, it will also appear on the other. and changes will be reflected on the other canvas, so control locations remain consistent. You can design different graphical layouts on the two canvases. |
Two map files |
- SAME area Use this option when you have two map files of the same area, but at different scales. Condes places the two maps on each their canvas. Condes assumes that one map is a direct enlargement of the other. When you create a control one one canvas, it will also appear on the other. and changes will be reflected on the other canvas, so control locations remain consistent. You can design different graphical layouts on the two canvases. - DIFFERENT areas Use this option when you have two adjacent or partly overlapping maps, where you want courses to cross from one map to the other (and back again). Condes places the two maps on each their canvas. When you create a control on one canvas, it will appear only on that canvas. When maps overlap, and you need a control to appear on both maps, simply create the control on both canvases. A control will have one control description, but you can move circles on the two canvases independently of each other. A course can span both maps - simply add the control codes to the course as usual; Condes will automatically detect which part goes on which map. |