Condes course planning - discussion forum
Welcome! Log In Create A New Profile

Advanced

Renumbering

Posted by Ali Wood 
Renumbering
May 20, 2018 05:24PM
I'm wanting to renumber my controls, but have specifc ranges of numbers available, and there doesn't seem to be a way to specify this?
Finn Arildsen
Re: Renumbering
May 26, 2018 11:03PM
Hi,

The renumbering feature respects the configured “first control code”. It also respects a predefined set of control codes, which you can configure using File / Settings for this PC. This is really meant as a set of punch pattern for the “backup” pin punches, but I think it is possible to omit the actual patterns an only enter the codes.

Regards
Finn
Author:

Your Email:


Subject:


Attachments:
  • Valid attachments: wcd,ocd,jpg,tif,png,jgw,tfw,pgw
  • No file can be larger than 62.5 MB
  • All files together cannot be larger than 62.5 MB
  • 5 more file(s) can be attached to this message

Spam prevention:
Please, enter the code that you see below in the input field. This is for blocking bots that try to post this form automatically.
 ********    *******   **    **  **     **        ** 
 **     **  **     **  ***   **   **   **         ** 
 **     **         **  ****  **    ** **          ** 
 **     **   *******   ** ** **     ***           ** 
 **     **         **  **  ****    ** **    **    ** 
 **     **  **     **  **   ***   **   **   **    ** 
 ********    *******   **    **  **     **   ******  
Message:
This is a moderated forum. Your message will remain hidden until it has been approved by a moderator or administrator