Condes course planning - discussion forum
Welcome! Log In Create A New Profile

Advanced

Renumbering

Posted by Ali Wood 
Renumbering
May 20, 2018 05:24PM
I'm wanting to renumber my controls, but have specifc ranges of numbers available, and there doesn't seem to be a way to specify this?
Finn Arildsen
Re: Renumbering
May 26, 2018 11:03PM
Hi,

The renumbering feature respects the configured “first control code”. It also respects a predefined set of control codes, which you can configure using File / Settings for this PC. This is really meant as a set of punch pattern for the “backup” pin punches, but I think it is possible to omit the actual patterns an only enter the codes.

Regards
Finn
Author:

Your Email:


Subject:


Attachments:
  • Valid attachments: wcd,ocd,jpg,tif,png,jgw,tfw,pgw
  • No file can be larger than 62.5 MB
  • All files together cannot be larger than 62.5 MB
  • 5 more file(s) can be attached to this message

Spam prevention:
Please, enter the code that you see below in the input field. This is for blocking bots that try to post this form automatically.
 **    **  ********   ********  ********  **     ** 
 ***   **  **     **  **        **    **  **     ** 
 ****  **  **     **  **            **    **     ** 
 ** ** **  **     **  ******       **     ********* 
 **  ****  **     **  **          **      **     ** 
 **   ***  **     **  **          **      **     ** 
 **    **  ********   ********    **      **     ** 
Message:
This is a moderated forum. Your message will remain hidden until it has been approved by a moderator or administrator