Tape Measure
|
<< Click to Display Table of Contents >> Navigation: Commands > Course Layout Editor Toolbar > Tape Measure |
![]()
You can use the Tape Measure tool to measure a distance on the map. The distance is measured along a route that you draw with the mouse. You draw the route as connected straight lines.
1Click the Tape Measure button to select the tool
2A "Tape Measure Length" window pops up. This window shows the length of the current route. Since no route is drawn yet, the length starts at 0 m.
3Click the left mouse button where you want to start the route, then click the left mouse button again, where you want the route to bend. The "Tape measure Length" window updates every time you click a new point.
4When you click the right mouse button, the last point on the route is removed. This allows you to "backtrack" the route.
Press ESC once to reset the Tape Measure, remove all points and start over. Press ESC again to close the Tape Measure tool.